30 lines
1.9 KiB
Markdown
30 lines
1.9 KiB
Markdown
|
# Promenade
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
The Promenade is a 60% ortholinear hotswap keyboard based on the split hand layout of the [Boardwalk](https://github.com/qmk/qmk_firmware/tree/master/keyboards/boardwalk). While similar to the Professional 2 hotswap version of the Boardwalk, it uses 1.5u verticle inner mods instead of 1u keys, includes a JST connector, adds stabilizer mounting positions for 6u and split 3u spacebards, and in addition to 60% tray mounting points the pcb has edge cuts for for use in gummy o-ring mount boards like the Bakeneko60.
|
||
|
|
|
||
|
|
The 1.5u vertical inner mods are the default configuration, but the board can be configured to use 3x2 1u keys either by removing the existing hotswap sockets and soldering 6 hotswap sockets to the 1u pads. *Note that the some of the 1u keys may require the plastic legs of 5-pin switches to be trimmed.*
|
||
|
|
|
||
|
|
* Keyboard Maintainer: [Feags](https://github.com/Feags) / [Krado Industries](https://kradoindustries.com/)
|
||
|
|
* Hardware Supported: Promenade pcb. Many 60% cases.
|
||
|
|
* Hardware Availability: [Krado Industries](https://kradoindustries.com/)
|
||
|
|
|
||
|
|
Make example for this keyboard (after setting up your build environment):
|
||
|
|
|
||
|
|
make kradoindustries/promenade:default
|
||
|
|
|
||
|
|
Flashing example for this keyboard:
|
||
|
|
|
||
|
|
make kradoindustries/promenade:default:flash
|
||
|
|
|
||
|
|
|
||
|
|
See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
|
||
|
|
|
||
|
|
## Bootloader
|
||
|
|
|
||
|
|
Enter the bootloader in 3 ways:
|
||
|
|
|
||
|
|
* **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
|
||
|
|
* **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
|
||
|
|
* **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available
|