# Processor frequency. # This will define a symbol, F_CPU, in all source code files equal to the # processor frequency in Hz. You can then use this symbol in your source code to # calculate timings. Do NOT tack on a 'UL' at the end, this will be done # automatically to create a 32-bit value in your source code. # # This will be an integer division of F_USB below, as it is sourced by # F_USB after it has run through any CPU prescalers. Note that this value # does not *change* the processor frequency - it should merely be updated to # reflect the processor speed set externally so that the code can use accurate # software delays. F_CPU = 16000000 # Input clock frequency. # This will define a symbol, F_USB, in all source code files equal to the # input clock frequency (before any prescaling is performed) in Hz. This value may # differ from F_CPU if prescaling is used on the latter, and is required as the # raw input clock is fed directly to the PLL sections of the AVR for high speed # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' # at the end, this will be done automatically to create a 32-bit value in your # source code. # # If no clock division is performed on the input clock inside the AVR (via the # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. F_USB = $(F_CPU) # Interrupt driven control endpoint task(+60) OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT # Boot Section Size in *bytes* OPT_DEFS += -DBOOTLOADER_SIZE=4096 VIA_ENABLE = yes VIAL_ENABLE = yes CONSOLE_ENABLE = no # Non debug builds should disable console SPACE_CADET_ENABLE = no # No need for space-cadet shifts on 3 key macro GRAVE_ESC_ENABLE = no # Not a 60% keeb so no need for grave escape COMMAND_ENABLE = no # Not enough keys to use command feature KEY_OVERRIDE_ENABLE = no # No modifier keys so no need for key override QMK_SETTINGS = no MOUSEKEY_ENABLE = yes # Mouse keys # opts LTO_ENABLE = yes AVR_USE_MINIMAL_PRINTF = yes