1998b3e69f
* Add support for CannonKeys db60 and Keebio BDN9 * remove db60 config from bdn9 * Removed suggested changes * updated a few keys for db60 * Removed erroneus db60.json and fixed rule.mk * Set unlock combo and removed rgb features not on board. * Added config for Keebio KBO-5000 Not totally sure if size of firmware is too close to the edge or how that impacts vial. 588 bytes free when building firmware. * Added security keys to keebio bdn9 * added RGB_Matrix_Enable * Update rules.mk for rev1 fw size limitations * Moved bdn9 keymap to rev2/keymaps/vial as rev1 build has firmware size limitation |
||
|---|---|---|
| .. | ||
| hotswap | ||
| j02 | ||
| keymaps | ||
| rev2 | ||
| chconf.h | ||
| config.h | ||
| db60.c | ||
| db60.h | ||
| halconf.h | ||
| info.json | ||
| mcuconf.h | ||
| readme.md | ||
| rules.mk | ||
CannonKeys DB60
DB60 "Daughterboard 60" Keyboard
- Keyboard Maintainer: Andrew Kannan
- Hardware Supported: STM32F072CBT6 (or equivalent)
Make example for this keyboard (after setting up your build environment):
make cannonkeys/db60/rev2:default
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Some notes about the versions: The original DB60 was shipped with the J-02. To build that, you will need to use the following command:
make cannonkeys/db60/j02:default
Solderable DB60s were shipped with keyboards after the J-02. This variant has cutouts along the top and bottom to support O-ring gasket mounting. To build these, you can use this command:
make cannonkeys/db60/rev2:default
Hotswap ANSI DB60s were shipped with the Bakeneko keyboards from CannonKeys. These also have the o-ring gasket mounting points. To build this:
make cannonkeys/db60/hotswap:default