qmk-keychron-q3-colemak-dh/keyboards/adafruit/macropad

Adafruit MacroPad RP2040

A RP2040-powered Macropad with a 3x4 layout.

• Keyboard Maintainer: Jpe230
• Hardware Supported: Adafruit MacroPad RP2040
• Hardware Availability: Barebones kit Starter Kit

Make example for this board (after setting up your build environment):

qmk compile -kb adafruit/macropad -km default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Features

• Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual-core Cortex M0+ at ~130MHz with 264KB of RAM.
• 3x4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
• One NeoPixel RGB LED per switch, on north side.
• Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.
• 128x64 SH1106 Monochrome OLED display - On high-speed hardware SPI port for quick updates.
• 8mm Speaker/Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects. (Unsupported for now)
• STEMMA QT Connector - Allows adding any I2C sensors/displays/devices with plug-and-play cables.
• Reset button - On the side, for quick restarting, press it twice to enter bootloader.
• Four M3 mounting bosses - Make custom enclosures easily.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the rotary encoder push-button on power-up or reset.
• Physical reset button: Press twice the button on the side while the board is connected.
• Keycode in layout: Press the key mapped to QK_BOOT if it is available.