History

David Hoelscher e9bd7d7ad3 I2C driver cleanup (#21273 ) * remove i2c_start and i2c_stop from i2c drivers * remove static i2c_address variable from chibios i2c driver		2024-01-17 14:05:38 +01:00
..
keymaps/default	Remove userspace keymaps (#22544 )	2023-11-27 05:36:45 +11:00
config.h	Migrate RGB Matrix config to info.json - RS (#22909 )	2024-01-16 01:03:55 +00:00
info.json	Migrate RGB Matrix config to info.json - RS (#22909 )	2024-01-16 01:03:55 +00:00
launch_1.c
post_rules.mk
readme.md
rgb_matrix_kb.inc
rules.mk	Dedupe I2C, SPI, UART driver inclusions (#22253 )	2023-10-13 17:25:32 +11:00
usb_mux.c	I2C driver cleanup (#21273 )	2024-01-17 14:05:38 +01:00
usb_mux.h

System76 Launch Configurable Keyboard (launch_1)

The Launch Configurable Keyboard is engineered to be comfortable, fully customizable, and make your workflow more efficient.

Additional Launch Keyboard resources:

Building Firmware

To build the firmware using make (after setting up the build environment), e.g.:

make -r system76/launch_1:default

Equivalently, using the QMK CLI:

qmk compile -kb system76/launch_1 -km default

To build and flash the firmware on the keyboard, e.g.:

make -r system76/launch_1:default:flash

Equivalently, using the QMK CLI:

qmk flash -kb system76/launch_1 -km default

To flash the firmware (and/or bootloader) using ISP refer to the ISP Flashing Guide.

Factory fuse values => Low: 0x5E, High: 0x99, Extended: 0xF3, Lock Bits: 0xFF

See the build environment setup and the make instructions for more information. If new to QMK, start with the Complete Newbs Guide.

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the key at (0,0) in the matrix (Escape) and plug in the keyboard.
Keycode in layout: Press the key mapped to QK_BOOT in the second layer (Escape).
Electrical reset: Briefly short AVR ISP's GND (6) and RST (5) pads on the back of the PCB.