History

Ryan f9aeea64c1 Migrate `MCU` and `BOOTLOADER` to data-driven (#19529 )		2023-02-08 18:41:46 +11:00
..
keymaps/default
config.h	Debounce defines cleanup (#19742 )	2023-02-03 19:19:58 +00:00
info.json	Migrate `MCU` and `BOOTLOADER` to data-driven (#19529 )	2023-02-08 18:41:46 +11:00
launch_1.c	Remove more RESET keycode references (#18252 )	2022-09-03 06:50:44 +01:00
launch_1.h
post_rules.mk
readme.md	RESET -> QK_BOOT keyboard readme (#18110 )	2022-08-20 11:34:17 +01:00
rgb_matrix_kb.inc	Change `DRIVER_LED_COUNT` to `{LED,RGB}_MATRIX_LED_COUNT` (#18399 )	2022-09-23 22:46:23 +10:00
rules.mk	Migrate `MCU` and `BOOTLOADER` to data-driven (#19529 )	2023-02-08 18:41:46 +11:00
usb_mux.c
usb_mux.h

System76 Launch Configurable Keyboard (launch_1)

The Launch Configurable Keyboard is engineered to be comfortable, fully customizable, and make your workflow more efficient.

Additional Launch Keyboard resources:

Building Firmware

To build the firmware using make (after setting up the build environment), e.g.:

make -r system76/launch_1:default

Equivalently, using the QMK CLI:

qmk compile -kb system76/launch_1 -km default

To build and flash the firmware on the keyboard, e.g.:

make -r system76/launch_1:default:flash

Equivalently, using the QMK CLI:

qmk flash -kb system76/launch_1 -km default

To flash the firmware (and/or bootloader) using ISP refer to the ISP Flashing Guide.

Factory fuse values => Low: 0x5E, High: 0x99, Extended: 0xF3, Lock Bits: 0xFF

See the build environment setup and the make instructions for more information. If new to QMK, start with the Complete Newbs Guide.

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the key at (0,0) in the matrix (Escape) and plug in the keyboard.
Keycode in layout: Press the key mapped to QK_BOOT in the second layer (Escape).
Electrical reset: Briefly short AVR ISP's GND (6) and RST (5) pads on the back of the PCB.