ebb512db82
* Clean up `DEBOUNCE` in config.h, 0-9 * Clean up `DEBOUNCE` in config.h, A * Clean up `DEBOUNCE` in config.h, B * Clean up `DEBOUNCE` in config.h, C * Clean up `DEBOUNCE` in config.h, D * Clean up `DEBOUNCE` in config.h, E * Clean up `DEBOUNCE` in config.h, F * Clean up `DEBOUNCE` in config.h, G * Clean up `DEBOUNCE` in config.h, H * Clean up `DEBOUNCE` in config.h, handwired * Clean up `DEBOUNCE` in config.h, I * Clean up `DEBOUNCE` in config.h, J * Clean up `DEBOUNCE` in config.h, K * Clean up `DEBOUNCE` in config.h, L * Clean up `DEBOUNCE` in config.h, M * Clean up `DEBOUNCE` in config.h, N * Clean up `DEBOUNCE` in config.h, O * Clean up `DEBOUNCE` in config.h, P * Clean up `DEBOUNCE` in config.h, Q * Clean up `DEBOUNCE` in config.h, R * Clean up `DEBOUNCE` in config.h, S * Clean up `DEBOUNCE` in config.h, T * Clean up `DEBOUNCE` in config.h, U * Clean up `DEBOUNCE` in config.h, V * Clean up `DEBOUNCE` in config.h, W * Clean up `DEBOUNCE` in config.h, X * Clean up `DEBOUNCE` in config.h, Y * Clean up `DEBOUNCE` in config.h, Z * Remove default debounce from info.json * Migrate non-default debounce to info.json |
||
|---|---|---|
| .. | ||
| keymaps | ||
| config.h | ||
| info.json | ||
| readme.md | ||
| rules.mk | ||
| zeno.c | ||
| zeno.h | ||
Zeno Ergo 60%
The following is the QMK Firmware for the Zeno 60% Ergo - 8 Degree ergo 60 designed in Dubai, UAE.
The PCB features:
- QMK & VIA compatibility
- Pre-configured Space-FN
- Keyboard Maintainer: paulgali
- Hardware Supported: ZenoPCB for the Zeno Ergo 60%
- Hardware Availability: https://sandkeys.me
Make example for this keyboard (after setting up your build environment):
make skme/zeno:default
Flashing example for this keyboard:
make skme/zeno:default:flash
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Bootloader Enter the bootloader in 3 ways:
- Bootmagic reset: Hold down the key ESC key and plug in the keyboard (Top Left most switch)
- Physical reset button: Briefly press the button on the back of the PCB
- Keycode in layout: Press the B key on layer 1 which is mapped to
QK_BOOT