You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 

81 lines
1.6 KiB

## freedv_eth config
##
## More output?
#verbose = 0
## NMEA device to use for location information
#nmea_device = /dev/gps
## Sound device to transceiver
#sound_device = default
#sound_device = hw:2
#sound_rate = 48000
## Valid values: left, right, 0, 1
## (left == 0, right == 1)
#freedv_rx_sound_channel = left
#analog_rx_sound_channel = left
## Name to use for new network device
#network_device = freedv
## Callsign to use for network device address
#callsign = pirate
## TX delay and tail in msec
#tx_delay = 100
#tx_tail = 100
## TX mode, valid options: freedv, analog
#tx_mode = freedv
## RX mode, valid options: none, freedv, analog, mixed
#rx_mode = mixed
## Fullduplex or not?
#fullduplex = 0
## Freedv Mode
#freedv_mode 2400B
## Rig
#rig_model = 1
#rig_file = /dev/ttyS0
#rig_ptt_file = /dev/ttyUSB0
#rig_ptt_type = NONE
#rig_dcd_type = NONE
#rig_conf_set = dtr_state ON
#rig_ctcss_sql = 719
#rig_ctcss_tone = 719
#rig_freq_rx = 145000000
#rig_freq_tx = 435000000
## Control text
## Use VC bits for control (1=VC bits, 0=data frames)
#control_vc = 0
## CTCSS
#analog_tx_ctcss_frequency = 0.0
# amp: 1.0 == full deviation (assuming 3kHz)
# 0.17 = about 500Hz
#analog_tx_ctcss_amp = 0.17
## Morse beacon
#analog_tx_beacon_interval = 0
#analog_tx_beacon_message = beacon
## Pre-emphasis on or off
#analog_tx_emphasis = 0
#analog_tx_beacon_sound_channel = left
#analog_rx_dcd_threshold = 1
#analog_rx_ctcss_frequency = 0.0
#analog_rx_gain = 1.0
## Output CTCSS tone on second audio channel
#analog_tx_tone = 0
## Set PTT to non-voice for analog tail (e.g. beeps)
#analog_tx_tail_other = 0
## Mute samples when DTMF is detected
#analog_dtmf_mute = 0